Loading
Eject water and clear dust from phone speakers using sound waves and vibration.
Plays a high-frequency water-ejection sound wave designed to shake water droplets out of speaker grills.
Fix My Speaker is a free online audio utility that helps remove trapped water and dislodge dust from smartphone speakers, earbuds, and smartwatch audio grills. When a phone is dropped in water or exposed to moisture, water droplets can get stuck in the fine speaker mesh, muffling sound and potentially damaging internal components. By generating specifically tuned sound waves between 165 Hz and 250 Hz alongside vibration pulses, this tool creates strong acoustic air pressure that forces liquid droplets out through the speaker vents.
No. The sound frequencies and volume levels used are completely within standard operating ranges for smartphone and mobile speakers. It will not blow out or harm your hardware when used normally.
A single cycle runs for 30 seconds. For mild moisture, 1 or 2 cycles are usually sufficient. If your phone was fully submerged in water, run 3 to 5 cycles until sound clarity is fully restored.
If sound remains muffled, there may still be moisture deep inside the speaker chamber. Allow the phone to stand speaker-down in a dry, ventilated area for 15–30 minutes, then run Sound Mode again.
Yes! Fix My Speaker works across all modern web browsers on iPhone, Android phones, tablets, smartwatches, and laptops with zero installation.
Help us enhance VelnoxLabs developer utility standards. Share your feedback below!